The Ressa seal RMDS range of automatic drop down door seals are designed for superior sealing performance in the gap between the bottom of the door and the floor.
1、 Open parallel groove in the center of the bottom thickness of the door bottom, according to different models, even parallel donations, measure the width of the door, according to the size of the most at the end of the bottom of the door without the knob to intercept the length of the door bottom sealing strip.
2, will intercept the bottom of the door sealing strip completely embedded in the groove, so that the bottom of the door sealing strip and the bottom of the door uniform.
3、 Screw the adjusting knob into the end of the push rod of the door bottom sealing strip on the side of the hinge, so that it will have the necessary impact with the door frame, and install the broadcast-resistant stainless steel sheet at the designing place of the door frame.
4. Close the door gently and observe the action of the sealing strip at the bottom of the door, you can see that the sealing strip slowly pops out and joins with the ground, and adjust the yellow knob to make the sealing strip at the bottom of the door join with the ground to reach the best state.
